Updating linux lenny

Remove "/" from etc/fstab, otherwise e2fsck will prevent the system from starting) setenv bootargs $(console) root=/dev/nfs rw nfsroot=10.0.0.1:/mnt/nas-root ip=10.0.0.1.0.0.1:::debian-armel:egiga0:none bootm 0x4000010.

Seagate Blackarmor 220 NAS hardware - Marvell Feroceon, 800 MHz, ARM926EJ-S, Sheeva CPU Core Technology - Marvell 88F6192 A0 LE Board, Kirkwood (the successor of Orion) So C series - 128 MB RAM - 32 MB Flash (Page 23, 25-33) Similiar devices: QNAP Turbo NAS (TS-119, TS-219 and TS-219P), LG N2B1DD1 series7.As of now, nobody has done this laborious work (forward port Seagates h/w-specific patches, compile and test the kernel) - This modification has been tested on a BA220 with fw 2000.0631.Update: It works on the BA420 (reported by lnxmnky) Update: It works on the BA110 (reported by tuxmania) Update: It works on the BA440 (reported by Isaac_X)3. On the front of the box on top and botom there are two vents that hide the little plastic case holders. ) Notes: - The SP modifies the original Seagate preroot image (NAND flash partition 2) to fix some bugs (Seagate/Wistron guys: 'exec /sbin/init' is the correct way to start the init process).Push them with a screwdriver and at the same time push the top of the case backwards. with password 'atsahs' Make sure to change the root password as soon as possible! Install Debian GNU/Linux 5.0.7 (Lenny) on the Blackarmor 220 NAS WARNING: This process completely replaces the original Seagate firmware! This modification should not affect the normal operation of the NAS (e.g. - The SP does not overwrite the official firmware image (NAND flash partition 4).

Search for updating linux lenny:

updating linux lenny-29

If you insert clean harddisks into your NAS, the official firmware gets installed (make sure to completely remove the GPT partition table which is located at the *end* of the harddisk).

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “updating linux lenny”